Loading

CA 42 USB TO UART DRIVER DOWNLOAD

Take another look at the schematic. We will use the other half of the cable in identifying its pinouts in the next step. Pin-out for the Nokia OEM cable: However, you can check with Nokia for the current versions as well. Strip the wires which correspond to pins 6, 7 and 8. For the file transfer, it gives me an error when I first open it, saying that the operation couldn’t be completed. This wire thermal covers are a piece of plastic that, in contact with heat not fire shrinks to fit perfectly the cable and the connector.

Uploader: Zoloshicage
Date Added: 8 September 2016
File Size: 58.98 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 97649
Price: Free* [*Free Regsitration Required]

A resettable fuse is highly recommended.

DIY USB to Serial Cable For $3! | Jonathan Thomson’s web journal

That is, if the top section was overlaid on the bottom all the vias would line up. So which cable is the one for my Nokia? Worked like a charm — the cable was instantly recognized as a serial port, and came up in device manager without the pesky yellow hsb mark.

Notify me of new posts via email. So now we know “what” and “where”, lets start soldering.

Do not be afraid you will break it, just make sure the Nokia or the “arrow” logo facing you like the second picture shown above, align with your handset’s Pop-port connector. Do not hook up your USB cable just yet.

Related Drivers  CANON INKJET MP730 DRIVER FOR MAC DOWNLOAD

Can Nokia CA USB cable be used to connect to RPi console? – Raspberry Pi Forums

Shutdown your computer, install the hard disk to your computer and reboot. I’ve searched using google about CA but not found the answer thanks. Well, there’s not much to elaborate on. Type U and hit Enter: Right now they are all stored to camera As a last resort, lay the unit uab. It sounds very straight-forward as Pop-port to USB connection. These cables vary a good bit.

How 422 are you with this reply?

Your cable may not have a pin 3 or pin 4 wire. Cut the cable into two. Click “Finish” button Message should appear at your taskbar that the driver has been installed: As per author’s request, this post will be updated when new information has been obtained.

This may or may not cause a timing problem when uploading. Sony Ericsson cables also use PL Probing There are most likely several different manufacturers of these cables because the same model will have a different number and color of wires depending on who you buy it from.

Related Drivers  EPSON M1400 DRIVERS

Nokia USB cable is USB-to-Serial in disguise

It appears you put the magical color changing reset capacitor directly on the cable. An original Nokia DKU-5 is not supported for a rather long time already.

I can easily find out which of the 3 wires went to where, but how should I find the pinouts of the other pins? Created by Us on And now in the other side of the wire we need to solder the wires to the 6 pin header with this schema: For improvement, add shrinkable tube: Too often there are just a bunch of out of focus smears none of which demonstrate what is c shown.

Just as I was considering cutting up a USB phone cable, I realised that I had a full-blown Linux system with a handily accessible serial port that uxrt at […].

Try one by one may still not recognized properly by your computer. Added a thread on edaboard — http: Does your pc recognize your phone?